This is the last item that was missing to get a fully working
runInWindowsVM function. Apart from checking exit codes, we also now
have preVM/postVM hooks which we can use to write arbitrary constructs
around this architecture, without the need to worry about specific
details.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
Later, when we start the actual builder, we're going to restore those
environment variables. We're using "(set; declare -p)", here, because
the former is just printing _all_ environment variables, even those not
supported, and the latter only lists specifically declared variables,
which also encludes exports.
The "declare -p" command also emits those variables in a format similar
to the "export" command.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
We now map all guest accounts to the root user, because in the end the
permissions of the current user boil down to the build user of the Nix
builder of the host. That way it's not possible to gain more permissions
at all and just makes the VM communication a lot easier.
However, setting "writable" to yes instead of "read only" to no doesn't
change anything here, I just found it to be clearer.
Also, we now no longer need to have a "nobody" user.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
This is done by putting the non-initrd /nix/store into a subdirectory,
which we then chroot to and pass along the SSH command.
Also, we now collect the exit code after the chroot command and power
off the VM thereafter, because the store is no longer shadowed and we
have still access to the busybox inside the initrd.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
This should trim down possible dependencies on the base installation and
hereby reduce the need for reinstallation of the damn VM to only changes
that affect the Windows installation and the base Cygwin + OpenSSH
setup.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
This now finally introduces our xchg share and also uses it for
exchanging state while suspending a VM. However, accessing the _real_
Nix store still isn't possible because we're shadowing the directory in
the initrd.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
Security-wise it's not a big issue because we're still sandboxed, but I
really don't want to write something like \\\\\\\\192.168.0.2\\\\share
in order to set up network shares.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
This could possibly cause flapping whenever qemu is too fast in starting
up. As we are running with the shell's -e flag, the socat check also
ensures that the VDE switch is properly started and causes the whole
build to fail, should it not start up within 20 seconds.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
These stages are in particular:
* Install of the bare Windows VM with Cygwin and shut down.
* Boot up the same VM again without the installation media and dump the
VMs memory to state.gz.
* Resume from state.gz and build whatever we want to build.
Every single stage involves a new "controller", which is more like an
abstraction on the Nix side that constructs the madness described in
276b72fb93.
Signed-off-by: aszlig <aszlig@redmoonstudios.org>
